Good morning guys, sorry, but I went to sleep last night. Yes, it’s not a Mesa board. I don’t want to spend money on it, and I haven’t sent you a picture, but in my opinion, it’s not worth spending on. I rewired everything from the Bob to the drivers, making a schematic of how they are connected. For example, the VFD was given to me brand new, so I have no idea how to make it work. As for the DIG probes, I checked their website, and they provide macros for MACH3, but what about LinuxCNC? I know that a macro is a series of G-code commands, but they might be different. Also, yesterday, I tried to do an initial configuration while following the guide. I got this error: Unexpected realtime delay on task 0 with period 50000 This message will only display once per session. Run the Latency Test and resolve before continuing. This error appears. I ran the latency test, but where do I input the values I found? 🥹