Hello everyone, I’m completely new to this world. I have experience with 3D printing, and I decided to get into milling just to make a few parts for my printers. I bought this machine, which has been sitting unused for 10 years. In my opinion, it seems quite solid and is equipped with long-version NEMA 23 motors. The previous owner told me he used to run it with Mach3, but he no longer has anything set up and advised me to use a PC with LinuxCNC. So far, I’ve installed LinuxCNC, and that part is done. Now comes the hard part… He doesn’t remember anything, and I find myself lost in a world I don’t know, with a ton of components to figure out. Can anyone help me with the setup? The board in question is a DB 25-1205, driving four DM542A drivers (XYZA). I also have two probes (one that mounts on the spindle and another for tool zeroing, branded DIG, 3 poles, both new). Additionally, I have a GPenny spindle with a matching VFD. Thanks a lot, and have a great evening, everyone!